|
|
 |
 |
 |
|
 |
| |
This section features information about the Komatsu Zenoah engines that are used in large scale radio controlled model cars.
This page features the special tools that are made by Komatsu Zenoah for maintaining and repairing their range of large scale model car engines. These tools are usually available from their distributors. |
 |
|
 |
|
|
 |
|
|
|
|
|
| Puller Assembly (#2890-96100) |
| Description |
Part Number |
Picture |
Intended Usage |
| Puller Assembly |
2890-96100 |
|
To remove rotor (fan). |
| Piston Stopper (# 4810-96220) |
| Description |
Part Number |
Picture |
Intended Usage |
| Piston Stopper |
4810-96220 |
|
Screws into spark plug hole to stop the piston moving, so that the crankshaft does not rotate when disassembling or assembling clutch and rotor |
| Rod Assembly (# 1101-96220) |
| Description |
Part Number |
Picture |
Intended Usage |
| Rod Assembly |
1101-96220 |
|
To remove/install piston pivot (gudgeon) pin |
| Snap Ring (Circlip) Pliers (# 5500-96110) |
| Description |
Part Number |
Picture |
Intended Usage |
| Snap Ring Pliers |
5500-96110 |
|
To remove snap rings (circlips) |
| Air Gap Gauge (# 3330-97310) |
| Description |
Part Number |
Picture |
Intended Usage |
| Air Gap Gauge |
3330-97310 |
|
To set ignition coil air gap |
| Hex Wrench (# 3304-97611) |
| Description |
Part Number |
Picture |
Intended Usage |
| Hex Wrench |
3304-97611 |
|
For 3, 4 and 5mm Allen cap screws on some of the Zenoah engine range. |
| Further Information |
| For help with the terms used throughout this series of pages, please see the Engine Terminology section. |
| If you have any comments or suggestions about this or any of the other R/C car content on the RcTek site, please feel free to ask them on our On-line Forum |
|
| Unless stated otherwise all images and content are Copyright (c) RcTek 2000/2001 |
|
