This section features information about the Komatsu Zenoah engines that are used in large scale radio controlled model cars.
This page features the special tools that are made by Komatsu Zenoah for maintaining and repairing their range of large scale model car engines. These tools may be available from their distributors.
| Description | Part Number | Picture | Intended Usage |
|---|---|---|---|
| Puller Assembly | 2890-96100 |  |
To remove rotor (fan). |
| Piston Stopper | 4810-96220 |  |
Screws into spark plug hole to stop the piston moving, so that the crankshaft does not rotate when disassembling or assembling clutch and rotor. |
| Rod Assembly | 1101-96220 |  |
To remove/install piston pivot (gudgeon) pin. |
| Snap Ring Pliers | 5500-96110 |  |
To remove snap rings (circlips). |
| Air Gap Gauge | 3330-97310 |  |
To set ignition coil air gap. |
| Hex Wrench | 3304-97611 |  |
For 3, 4 and 5mm Allen cap screws on some of the Zenoah engine range. |