RcTek Home  RcTek : PB Racing Dart 1/5th Scale Car Build Manual
Home Technical Information FAQ Tips & Tricks Site Map Forum Links  
  These files were derived from the original manual files and have been published as separate files, as one whole file would have may have been too big for some people.

All these files are in PDF format and if you `mouse over` the pictures, you will see what the size of the file is.
R/C Model Car Info  
Section Contents
  Notes
There were a few design changes after this manual was produced, they are listed after the manual section at the bottom of the page. MoreRead More..
We have also produced a reference chart of the nuts and bolts, etc.. that hold together a car. MoreRead More..
  PB Racing Dart Manual
Introduction - 446kb Shock Absorbers - 170kb Differential - 307kb Front Axles -188kb Front Brakes - 356kb Front Suspension - 391kb
Introduction Shock Absorbers Differential Front Axles Front Brakes Front
Suspension
Servo Saver - 200kb Body & Bumper Mounting - 120kb Zenoah Tank Mounting - 78kb Dynamic Tank Mounting - 171kb Rear Blocks - 100kb Rear Suspension - 655kb
Servo Saver Body
Mounting
Zenoah Tank Mounting Dynamic Tank Mounting Rear Axle Blocks Rear Suspension
Layshaft & Gears - 403kb Rear Brake & Throttle - 241kb Rear Anti-Roll Bar - 222kb Radio Plate - 195kb Engine & Clutch Mounting - 257kb Suspension Setup - 38kb
Layshaft & Gears Rear Brake & Throttle Rear Anti-Roll Bar Radio Plate Engine/Clutch Suspension Setup
  Fixings Chart
Dart Fixings - 42kb We have compiled a PDF reference chart of all the nuts & bolts, etc.. that go into the building of a PB Racing Dart kit. These are full sized drawings that you can identify and compare the fixings you have or have been supplied with.

Click the image to download the file.
  Design Changes
Although there were more changes made, the items below are the most relevant.
The clutch was adapted so that five of the disc springs could be fitted instead of the original three.
The alloy studs that were fitted in the front axles were changed for high tensile grub screws. This did cause a problem with the length of the axle, see Building Tips for more info.
Further Information
If you have any comments or suggestions about this or any of the other R/C car content on the RcTek site, please feel free to ask them on our On-line Forum
Top of Page
Home  Technical Information  FAQ  Tips & Tricks  Car Information  Site Map  Forum  Links